[. . . ] On the work environment, the workpiece, the workpiece support and the number of fastener driving processes. In correspondence with conditions at the work location, individual noise reduction measures may need to be carried out, such as placing the workpiece on a noise-suppressing surface, clamping or covering to prevent workpiece vibration and adjusting to the minimum pressure required by the work process. 5 m / s2 Mechanical impact (vibration) The vibration value for the fastener driving device was determined in accordance with ISO 8662-11:1999 — Hand-held portable power tools – Measurement of vibrations at the handle — Fastener driving tools (see technical data). The value is referenced to the device and does not represent the influence on the hand-arm system when the device is used. [. . . ]  Remain alert at all times, watch what you are doing and always proceed with caution when working with a fastener driving tool. Do not use any fastener driving tool if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the fastener driving tool may result in serious injuries. By doing this you will be in a better position to control the fastener driving tool in unforeseen circumstances.  Before any repair and maintenance work or transport, remove the device from the compressed air source.  Never use hydrogen, oxygen, carbon dioxide or other bottled gasses to power this tool as doing so may result in an explosion and thus may cause severe injuries. Do not use the device if RISK the trigger lock 8 is damaged or has been removed. Safety  ever point a fastener driving tool that N is ready to use directly at yourself, other persons or animals.  uring work, hold the fastener driving D tool so that head and body can not be injured by possible kickback due to a fault in the power supply or from hard places in the workpiece. Following this instruction will prevent danger due to uncontrolled flying fasteners and overloading the device.  Before transporting, disconnect the fastener driving tool from the compressed air network, particularly when using ladders or are moving with an unaccustomed body posture. The fastener will only leave the device when the mouth of the compressed air tacker is pressed against the workpiece and the trigger 2 is actuated.  that the fastener has been driven in corCheck responding to the work requirements. €“ If the fastener is protruding, increase the air  pressure in 0. €“ f the fastener is too deep, decrease the air I pressure in 0.  an alternative, you can accelerate the work As by keeping the trigger 2 depressed.  the device against the workpiece until the Press mouth 9 touches it. long as the trigger 2 is kept depressed, each As time the mouth 9 touches the workpiece one fastener will leave the device.  Another alternative is to keep the mouth 9 pressed against the workpiece.  time the trigger 2 is actuated, a fastener Each will leave the device.  the knurled screw 7 downwards in order Turn to drive the fastener more deeply into the workpiece.  the knurled screw 7 upwards in order to Turn drive the fastener less deeply into the workpiece. [. . . ] Maintenance and cleaning / Service / Warranty / Disposal Manual lubrication NOTE: If you do not have an oil mister, lubricate the device each time after driving about 5000 fasteners.  pply 1–2 drops of special compressed air oil A into the threaded nipple 4 of the compressed air tacker. Then ATTENTION: Be certain not to use too much oil; otherwise oil could leave the mouth with the fastener and potentially damage the workpiece. The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. [. . . ]